Neumann M150 Tube Stereo (230 Volt Euro) Omnidirectional tube mic, N 149 A

Neumann M150 Tube Stereo (230 Volt Euro)

Omnidirectional tube mic, N 149 A

Varenr: 8462
77 676,-
Logg inn for å se din forhandlernetto.Søk om å bli forhandler her.
BeskrivelseTeknisk info
Beskrivelse
A redesigned classic with state-of-the-art circuit technology and correspondingly low self-noise. Like the legendary M 50, this tube microphone is ideal for orchestral recording.
Teknisk info
Acoustical operating principle                                        Pressure transducer
Directional pattern                                                        Omnidirectional
Frequency range                                                          20 Hz ... 20 kHz
Sensitivity at 1 kHz into 1 kohm                                    20 mV/Pa
Rated impedance                                                         50 ohms
Rated load impedance                                                  1 kohms
Equivalent noise level, CCIR1)                                        28 dB
Equivalent noise level, A-weighted1)                               15 dB-A
Signal-to-noise ratio, CCIR1) (rel. 94 dB SPL)                  66 dB
Signal-to-noise ratio, A-weighted1) (rel. 94 dB SPL)         79 dB
Typical SPL (tube characteristic)2)                                 K < 0,5 %: 114 dB, K < 5 %: 134 dB
Maximum output voltage  8 dBu
Dynamic range of the microphone amplifier (A-weighted)  K < 0,5 % *: 99 dB, K < 5 %: 119 dB
Powering  Power supply                                                N 149 A
Matching connector microphone                                    DIN8F
Matching connector power supply                                  XLR3F
Weight                                                                        800 g
Diameter                                                                     78 mm
Length                                                                        165 mm
______________________________________________
1) according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2) measured as equivalent el. input signal